Product Overview
High performance car audio amplifiers love lots of signal voltage. This allows them to deliver optimum sound quality and maximum bass response. Unfortunately, many of today’s after market source units don’t output the optimum voltage levels these amplifier need. The AudioControl OVERDRIVE PLUS pre-amp line driver increases the line level signals from aftermarket source units up to 13 volts max (9.5 RMS) and delivers them downstream to the amplifiers inputs. The results are increased dynamic range, maximum signal-to-noise levels, and tremendous bass response. Autosound enthusiasts will enjoy dramatically improved sound quality of their after market audio system.
Once connected, the Overdrive Plus makes it easy to set the gain — LEDs indicate whether you're just inside the Overdrive Plus's minimum working range or approaching its maximum voltage without clipping the signal. Balanced inputs reject noise caused by your vehicle's electrical system, but you can switch to unbalanced operation if necessary. The Overdrive Plus's low-impedance output keeps your signal going strong through long cable runs.
AudioControl created the Overdrive Plus line driver to ensure that your amp sees the cleanest signal possible. Many modern car stereos boast 4- and 5-volt preamp outputs, but they're rated at full output. Turn your stereo to a normal listening level, send the signal through a 20-foot cable, and your amps may end up with just a couple of volts. The Overdrive Plus solves this problem by boosting the signal from your car stereo, and it also allows you to control your amp's level from the front seat with an optional remote.
High signal voltage capability: 9.5 volts RMS output
24dB of gain
Input for optional Dash Control for remote level
Ultra-low distortion, ultra-quiet operation
Low noise, high current output circuitry
High-headroom PWM switching power supply
Selectable ground isolation
Voltage indicator LEDs
Higher voltage = lower noise
The Overdrive Plus line driver boosts the signal from your receiver up to 24 dB, right up to the maximum level accepted by your amplifier or processor. The high-voltage level keeps the noise out of your system, while feeding your amps the signal they need to deliver top performance.
Easy adjustment
Once connected, the Overdrive Plus makes it easy to set the gain — LEDs indicate whether you're just inside the Overdrive Plus's minimum working range or approaching its maximum voltage without clipping the signal. Balanced inputs reject noise caused by your vehicle's electrical system, but you can switch to unbalanced operation if necessary. The Overdrive Plus's low-impedance output keeps your signal going strong through long cable runs.
